What happened when the distance between the lithium battery coating section often changes?

　　1. The length of the lithium battery coating section is large (shorter) and the spacing changes are small (narrow)

　　cause of issue

　　1) The surface of the back roller and the rear rubber roller is not clean,

　　2) The gap between the back roller and the rubber roller is too small and too tight,

　　3) The tension does not match before and after, and the volume is greater than the receipt

　　Solution:

　　1) Clean roller

　　2) Adjust the oblique block to the fixed position

　　3) Refer to the setting parameter adjustment

　　2. Large change (*shorter) The spacing changes are large (bigger)

　　cause of issue

　　If the length of the head and the next head of the pole film and the next head, if the changes are large (small), the tail changes between the two sections of the pole film change less, so that the solenoid valve (control rubber roller movement) is not flexible

　　3. Large change of section (*change)*The distance changes are large (wider)

　　cause of issue

　　1) The surface of the back roller and the rear rubber roller is not clean,

　　2) There is no clamping roller, maybe there is no clip or out of control. 3) The tension does not match the tension before and after.

　　solution

　　1) Clean roller

　　2) Add clamp roller

　　3) Refer to the setting parameter adjustment

Read recommendations:

lithium deep cycle marine battery wholesale

36 volt golf cart batteries

Low Temperature Lithium Battery 26650 Cell

Enhancing Lithium Battery Safety: The Importance of Fireproof Storage Solutions

12V modular iron phosphate battery.lithium ion golf cart batteries