Precautions for lithium battery coating machine

　　1) The operator must receive pre -job training and pass the assessment before the job can be served, and this operation regulations shall be strictly abide by this operation.

　　2) In addition to the necessary maintenance personnel, it is strictly forbidden to operate the equipment or change the setting parameters.

　　3) The roller speed ratio is recommended in the range of 1.3 ~ 1.5.

　　4) It must be confirmed that the dry fan has been started before the air heater can be started.

　　5) When adjusting the gap between the coating roller and the back roller, the slurry on the coating roller should just be wiped off without stuck the back roller. It must ensure that the two rolls are parallel and the gap is consistent (there must be a gap).

　　6) After resetting the parameters, you must press the entry button to change the parameter.

　　7) After each shift is stopped, it must be cleaned with alcohol or acetone immediately. Wash the fight, scraper, coating roller and back roller. The surface must not be scratched and damaged.

　　8) Pay attention to keep the back roller cylinder and the straight -line sliding rail clean and lubricated.

　　9) The machine bearing site must be lubricated regularly, and the reducer must be replaced or supplemented regularly.

　　10) Once the problem is found, the problem must be recorded and notified the relevant departments in time in order to deal with it in time.

　　11) Do the work 58 at all times to maintain the neat equipment and the surrounding environment.

Read recommendations:

deep cycle marine battery Processing

solar generator for camping

32700 3.2V Special Battery Cell Rechargeable Explosion Proof

Optimizing Power Solutions: The Versatility of 72V Lithium Batteries for Modern Applications

Advantages of polymer lithium batteries.lifepo4 battery 12v 200ah