What aspects should be paid attention to using lithium battery coating machines

　　1. Preparation before booting

　　1) Check the electrical switches, whether there are abnormal phenomena such as falling off or damage.

　　2) Put the traction band at normal temperature stop according to the process of craft roads.

　　3) Start the exhaust equipment.

　　4) Confirm that there is no bright fire (such as electric furnaces, etc.) in the coating machine room.

　　5) The coating machine control cabinet and dry box shell must be reliable.

　　2. Power process

　　1) Combine the power switch and the power switch on the control cabinet.

　　2) Set the initial value (generally 180 ~ 280) and the frequency frequency (usually 20 ~ 50) on the tension controller.

　　3) Set the coating working method and related parameters (coating speed, section length, gap length, roller speed ratio, etc.), and then connect the compressed air (adjust the pressure control box regulating valve between);

　　4) Start the dry fan and dry temperature controller.

　　5) Connect the power supply of automatic correction and tension controller.

　　6) The temperature of each section of the device has reached the temperature requirements of the process;

　　7) Fighting the coating device, and start the coating machine at the same time for the coating.

　　3. Shipping program

　　1) It is confirmed that the coating pole has been wrapped, and then stops.

　　2) Turn off the power supply of the device, and when the temperature of each section drops to less than 60 degrees Celsius, stop the dryer and other fan;

　　3) Stop compressed air.

　　4) Disgle the power on the correction cabinet and the control cabinet.

Read recommendations:

lifepo4 battery 12v

solar power storage

18650 Na-ion Sodium-ion Battery 3.1V 1300mAh 1500mAh 3000 Cycles

The Ultimate Guide to 36V Lithium Batteries for Trolling Motors and Marine Use

What are the potential safety hazards of 3C lithium-ion battery?