Differences in charging methods between lithium battery and nickel hydrogen battery.solar energy storage batteries direct sales

　　In the process of battery use, many consumers often have the same concept of battery use. Now lithium batteries have become the mainstream, but the previous use of nickel metal hydride batteries is still used in lithium batteries. In fact, lithium batteries and nickel metal hydride batteries are different in use except for their products.

　　Newly purchased lithium battery: For the first three times, use the battery until it shuts down naturally, then use it with the original direct charge until the phone is fully charged, and then continue to charge for about 1 hour (about 2 hours above 2000 mah).

　　Daily: It can be filled when it is full, and the subsequent filling should not exceed 1 hour. Avoid late night charging (high grid voltage). The battery can be charged at any time and can be used for alarm or shutdown. Note that the battery used for shutdown shall be charged as soon as possible, otherwise, the battery self discharge and voltage drop may cause the self-locking protection cannot be charged. To form a habit, go to work during the day and home at night, start charging, and unplug the power after charging or before leaving or sleeping.

　　Use: General lithium battery can be charged, used and stopped at any time. The cycle life refers to the times of full charge and discharge, and partial charge and discharge can be understood as a fraction of the life. The key to using the battery: The battery is fully charged, and it can be charged for 20 minutes to half an hour to reach saturation, but it must be avoided to charge for a long time after being fully charged. If the battery is charged for a long time after it is full, it will cause side effects. As a result, the capacity will decrease and the internal resistance will increase. The capacity will be shortened and the battery will be shut down as soon as a call is made. PPC and other charged chip machines should always be recharged when the power is off, mainly considering the problem of power display metering.

　　Recharging after the battery is fully charged will do great harm to the lithium battery. If the battery is charged continuously after it is full, there will be side reactions in the battery. Active substances will decrease, garbage will increase, capacity will decrease, and internal resistance will increase. Severe overcharge will directly damage the battery structure, leading to battery scrapping. Now some chargers also provide a charging protection mode, which can adjust the charging mode according to whether the battery is fully charged, which can effectively protect the battery.

Read recommendations:

solar battery storage system Factory

12v 200ah battery

LiFePo4 Battery Pack 12V 350Ah

The Power of 18650 3.7V Batteries: A Comprehensive Look

Characteristics of high magnification lithium polymer battery